Striped Bass How-to: Trolling the Deep Divers - The Fisherman

Striped Bass How-to: Trolling the Deep Divers

2017 11 Trolling The Deep Divers Boat

If trolling stripers is on your fall itinerary, you’d be foolish not to take advantage of this highly effective technique.

My introduction to trolling deep diving plugs for stripers came by way of Mann’s Stretch 25s. That initial attempt left quite an impression as the stripers were all over them. Later that same fall, with my son Roger and Dave Morell, I was pulling a spoon on wire, and a Stretch 25 on the other rod. As soon as the line came tight on the plug, the rod bent over, and the reel started screaming.  Once that fish was in the box, I let out the plug again with the same result.  While Roger fought that fish I pulled in the spoon and let out a second plug.  It was loaded up before Rog got his fish to the net. I had developed a new-found respect for the effectiveness of trolling deep diving plugs on braided line.

While the term “stretch” has become nearly as universal (read: ubiquitous) as Coke or Kleenex, deep-diving plugs for inshore and offshore trolling continue to evolve with new and improving lines from Yo-Zuri, Bomber, Rapala, and others. They continue to earn loyal converts, not just for their effectiveness but for the overall simplicity of putting baits to precise depths where fish are feeding.

Rig, Drop & Troll

Everything about fishing these plugs is easy, which is one reason they are quickly gaining in popularity. Rigging is as simple as a 6-foot leader of 50-pound mono – I favor pink Hi-Seas or Ande for their abrasion resistance – with one end tied to the split ring on the plug. I tie a perfection loop at the other end, and attach the perfection loop to my running line with a ball bearing Cross-Loc snap swivel.

2017 11 Trolling The Deep Divers Photo By Dan DiPasquale
Photo by Dan DiPasquale

Thirty-pound braid is my first choice as a trolling line for these plugs, but there are some people out there who continue to fish with mono, believing that the stretch provided by monofilament acts as a shock absorber when a fish hits, as well as during violent head shakes. On the other hand, braid, due to its thin diameter, allows the plug to dive to its maximum depth.  The fact that braid does not stretch requires the drag to be set a bit on the lighter side.

You do not need expensive tackle to troll deep diving plugs for stripers. Any mid-size, braid capable conventional reel and medium to medium/heavy action trolling rod in the 7-foot range gets the job done. A soft tip section gives the plug the freedom to swim effectively, and tells you when the plug is working correctly. When a deep diving plug is working correctly, the rod tip has a constant vibration.  If the vibration stops, the plug is fouled and must be brought in and cleaned.

Trolling speed with these plugs is as slow as the boat will go.  I often run my 24 Albemarle at idle speed, and that works pretty well unless I’m running against a strong current.  As a general rule, I avoid running against strong currents, but often use the current to work the plug in the strike zone by running parallel to fish-holding structure like bridges, rips and shoals. Fishing parallel to these structures allows the plug to be swept down-current and into the feeding zones of stripers. Another method is to hold the boat up-current of the structure and allow the plug to work back over a shoal, into a rip or into the shadow line of a bridge.

2017 11 Trolling The Deep Divers Mike Pizzolato With A Delaware Bay Striper Caught On A Stretch
A Mann’s Stretch 30 trolled on braided line went deep for this nice striper. Photo By Dan DiPasquale.

Most of the time a deep diving plug runs straight, but there is the occasional one that wants to pull to starboard or port.  Sometimes this can be corrected by bending the eye on the plug away from the direction you want it to go and sometimes not.  When it can’t be fixed, simply place the plug on the port side if it wants to run to port or on the starboard side if it runs to starboard. This little quirk does not seem to affect the fish-catching ability of these lures.

Hitting the Mark

When letting the plugs back it is easy to see how far behind the boat they are because they float.  Most of these plugs work effectively when towed between 50 and 100 feet behind the boat. Most plugs have an optimum trolling distance that allows them to reach their targeted depth. Be very careful when turning that one plug does not overtake the other.  If they do mate, the ensuing mess requires some major surgery to repair. Bomber, for example, makes their Certified Depth, or “CD” series in 25 and 30 models meaning they’re designed to work most effectively at 25- and 30-foot depths respectively.  They hit that sweet spot with about 60 feet of 50-pound braid out while trolling at 4 to 5 knots.  The X-Rap Magnum from Rapala comes in 10, 15, 20, 30 and the new X-Rap 40 model, and reaches optimum depth with approximately 100 feet of line out.

2017 11 Trolling The Deep Divers Photo Fight By Gary Caputi
Late fall trolling sessions require getting your lures down into the strike zone. Trolling deep-diving plugs on braid will make it happen. Photo by Gary Caputi

These types of plugs perform as advertised so long as the conditions are to their liking.  The thin braid line allows the plugs to dive to the correct depth while heavy mono keeps them above this level.  As mentioned before, pulling the plug faster brings it up in the water column – go too fast and they tend to go around in circles and jump out of the water.  The newly introduced Yo-Zuri High Speed Vibe, on the other hand, can be trolled at speeds up to 15 knots, making them equally as effective for wahoo offshore as they are inshore on the striper grounds.  Just keep in mind the more line out, the deeper the dive.

If for whatever reason you would like the plug to go even deeper than conditions allow, you can try a couple of things.  The first is to add a drail between the leader and the running line, using heavier weights to get deeper. Some captains I know use drails ranging from 4 to 8 ounces, while lengthening their leader to as much as 20 feet.

Running the plug on wire line is another trick you can try.  Here too the drail goes between the leader and the running line, and the leader will be about 20 to 30 feet long.  Another wire line rig makes use of a three-way swivel.  A tear drop sinker in the 10- to 16-ounce size is dropped about 4 feet below the three-way using a length of 30-pound mono.  The plug goes on one of the other eyes behind 30 feet of 50-pound leader.  This rig would be used in deep water when stripers are holding along a channel edge.

This fall when the stripers start running south along the oceanfront, give deep diving plugs a shot.  They’re effective trolled inside the 3-mile line along the fence in state waters, and they can be used around schools of breaking fish by trolling the edges of the action.  Since the largest of the stripers usually feed close to the bottom, a deep diving plug may make the difference between hooking a big cow or a bunch of rats.



With the variety of trolling plugs on the market, the common question for anglers with assorted plug brands in the box is, “so is there a standard?”  Starting with a running speed of 4 to 5 knots with 50-pound braid, we posed that question to a few of the major manufacturers.

2017 11 Trolling The Deep Divers Bomber CD
Bomber CD

For the folks at Bomber, lay out 55 feet of line with the Bomber CD25 and your plug will dive to 25-foot depths; 100 feet of line will get your Bomber CD25 to 34 feet, while 150 feet of line will get to 40 feet.  By comparison, the Bomber CD30 will get to 30 feet with 55 feet of line out, 42 feet of depth with 42 feet of line and 50 feet of depth with 150 feet of line.

2017 11 Trolling The Deep Divers Yo Zuri Crystal Minnow
Yo-Zuri Crystal Minnow

The new sinking 5-1/4-inch High Speed Vibe from Yo-Zuri runs at various depths when trolled from 4 to 15 knots; while the 3D Magnum DD 7-inch wiggles well at 20- to 25-foot depths when trolled between 4 and 8 knots with roughly 100 feet of line deployed.  For shallower applications, consider the Yo-Zuri Crystal 3D Minnow Deep Diver (20-foot depth) or Crystal Minnow Deep Diver (13-foot depth) in 6-inch sizes.

2017 11 Trolling The Deep Divers RAPALA XRAP MAGNUM
Rapala XRAP Magnum 40

Mike Weinhofer at Rapala said specific questions on trolling behavior are tough to tackle as there are many variables when trolling, including fluoro or wire leaders, trolling with or against the current, use of release clips and the likes.  Rapala’s X-Rap Magnum comes in 10, 15, 20, 30 and new X-Rap 40 and generally reaches optimum depth with approximately 100 feet of line out.

Mann’s Mike McPherson added that rod height above water will create changes in depth (Guys running rods out of a tower/T-top rodholder down the center is always an issue.).  “The Mag 40 at 5 mph generates 5 to 6 pounds of drag, so 30-pound gear is a must,” McPherson said, adding “Light drag and soft rod tips when using braid keep fish on better.”


Look on the packaging for recommendations; if there are charts, graphs or instructions on the box itself, try to remember to cut that part out and tape to the inside of the tackle tray where you store your trolling plugs for onboard reference.  Best bet though is to experiment this season when marking fish and keep notes in your fishing log for future efforts.  Once you’ve got the down and distance figured out, it’ll make fishing these plugs that much easier.



Around The Island: July Striper Spotlighting

The month known to produce some of the largest stripers of the year.

Crossover Casts: Freshwater Tactics For Striped Bass

Tips from pros like Mike Iaconelli for applying freshwater techniques to striped bass fishing.


Around The Island: June Striper Spotlighting

Touching upon Long Island’s June striper hot spots.